Changing the PIN code (and pairing the FOB)

Changing the PIN code on the Start Panel is easy. The code can consist of 4-6 digits. Remember that if you use a FOB, it must be paired again after changing the PIN.

1. Remember to write down the new PIN code before you start.

2. Check that the main power switch is turned “ON”.

3. Enter the existing PIN (the factory default code is 1-2-3-4) (LED flashes GREEN)

4. Press and hold the “ON/OFF” button on the Start Panel for approximately 5 seconds. (LED flashes BLUE)

5. Press the “2” key to change the PIN code. (LED flashes rapidly ORANGE)

6. Enter your new PIN code. It can consist of 4-6 digits.

7. Press “START” on the Start Panel to confirm the entry. (LED flashes rapidly GREEN)

8. Enter the new PIN code once more and confirm with the “START” button. (LED lights GREEN, acknowledges with 2 beeps and then flashes BLUE)

NOTE! If you enter a different PIN code, the LED will light RED and give a long beep. Wait until the LED flashes ORANGE again and continue from step 6.

9. The PIN code has been changed. (LED flashes BLUE)

NOTE! If you have a FOB, it must now be paired again using steps 10-13, otherwise you can continue from step 14.

10. Press the “1” key to pair the FOB. (LED flashes rapidly ORANGE)

11. Press and hold the “ON/OFF” button on the FOB.

12. After approximately 3 seconds, the Start Panel’s LED changes from ORANGE to GREEN and acknowledges with 2 beeps.

13. Release the “ON/OFF” button on the FOB.

14. The FOB is paired. (The Start Panel’s LED flashes BLUE)

15. Press the “ON/OFF” button on the Start Panel to exit PROGRAMMING mode.

16. Remember to test that the FOB is paired correctly.